Filter
Top Products
Getting Connected 87
10.2 Connecting to the Internet
Your device is preconfigured to connect to the Internet using your service provider’s data network. However,
you can also use Wi-Fi or dial-up to connect your device to the Internet or you company network.
Wi-Fi
Wi-Fi provides wireless Internet access over distances of up to 100 meters. To access the Internet via Wi-Fi on
your device, you need access to a wireless network or hotspot.
Note The availability and range of your device’s Wi-Fi signal depends on the number, infrastructure, and other objects
through which the signal passes.
To turn Wi-Fi on and off
At the lower left side of your device, slide the WLAN Switch upward to turn Wi-FI on, downward to turn Wi-Fi
off. The icons on the switch represent the following:
: Wi-Fi is turned on.
: Wi-Fi is turned off.
To connect to a wireless network or hotspot
1. After Wi-Fi has been turned on, your device then scans
for available wireless networks or hotspots in your area.
The network names of the detected wireless networks
will be displayed on a pop-up message window. Tap
the desired wireless LAN, then tap OK.
2. On the next pop-up message window, tap The
Internet if the wireless LAN connects your device to
the Internet. Otherwise, tap Work if the wireless LAN
connects your device to a private network.
3. If the wireless LAN is secured by a network key, enter
this key, then tap Connect.
Next time you use your device to detect wireless
networks, you will not see the pop-up message
windows again, and you will not be prompted to enter
the network key of the previously accessed wireless
network (unless you perform a hard reset which will
erase custom settings on your device).
Note Wi-Fi networks are self-discoverable, which means no additional steps are required for your device to connect to
a Wi-Fi network. It may be necessary to provide a username and password for certain closed wireless networks,
however.