Filter
Top Products
130 Appendix
A.2 Regulatory Notices
Regulatory Agency Identifications
For regulatory identification purposes, your product is assigned a model number of TITA100.
FCC ID: NM8TITA100. IC:4115A-TITA100.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with
your TITA100.
The Battery Pack has been assigned a model number of TRIN160.
This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1
Amp power supply unit.
Federal Communications Commission Notice
DECLARATION OF CONFORMITY
UT Starcom hereby declares that this wireless device, TITA100, manufactured by High Tech Computer Corp.,
is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy
of the original declaration of conformity can be found at the following Internet address: http://www.danger.
com/consumers.php
This wireless device, TITA100, manufactured by High Tech Computer Corp., complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Responsible Party: High Tech Computer Corp.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or TV reception, which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or television technician for help. Modifications not expressly
approved by the manufacturer could void the user’s authority to operate the equipment.
FCC RF EXPOSURE INFORMATION
In August 1996, the Federal Communications Commission (FCC) of the United States with its action in
Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency
electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the
safety standard previously set by both U.S. and international standards bodies. The design of this device
complies with the FCC guidelines and these international standards.