Filter
Top Products
165
CLIÉ Remote Commander
Chapter 8
You can operate a remote-controlled device on the device’s control
screen. For those operations you have assigned to the Jog Dial
™
navigator or to the application buttons, see page 166.
Notes
• Be sure to point the IR port of your CLIÉ handheld toward the
device that you wish to remote-control.
• The reach of the remote-control signal is approximately 5 meters, but
it may vary depending on the receiving device or on the
environment.
• Some buttons on the CLIÉ Remote Commander application’s control
screen would not work if the remote-controlled device is not
equipped with that function. Note also that some functions may not
work depending on its model.
Remote-controlling a device
Operating a device from the control screen
1
On the Application Launcher screen, rotate the Jog Dial
™
navigator to select CLIÉ RMC and press the Jog Dial
navigator.
Or, tap the CLIÉ RMC icon on the Application Launcher screen.
The CLIÉ Remote Commander application starts and control screen
for the last used device appears.
Note
If the setting for the last used device has been deleted, the Select Control
screen appears.
2
Perform either of the following to switch to the control
screen of the device you are about to remote-control.
• For devices assigned to a quick-start button:
Tap the quick-start button to which it is assigned.
• For devices unassigned to a quick-start button:
Tap Select, then tap to select the name of the remote
control setting from the list.
The control screen for the selected device appears.
Using the CLIÉ handheld as a remote
control
Continued on next page