Filter
Top Products
© 2003 Sipura Technology, Inc Proprietary (See Copyright Notice on Page 2)
8
o To input: W, X, Y, Z, w, x, y, z -- press ‘9’
o To input all other characters in the administrator password, press ‘0’
Note: This translation convention only applies to the password input.
For example: to input password “test#@1234” by phone keypad, you need to press the following
sequence of digits: 8378001234.
2. After entering a value, press the # (pound) key to indicate end of input.
o To Save value, press ‘1’
o To Review the value, press ‘2’
o To Re-enter the value, press ‘3’
o To Cancel the value entry and return to the main configuration menu, press ‘
*’ (star)
Please Note:
o The final ‘#’ key will not be counted as part of the value.
o Saved settings will take effect when the telephone is hung-up and if necessary, the SPA-
2000 will automatically reboot.
3. After one minute of inactivity, the unit times out. The user will need to re-enter the configuration
menu from the beginning by pressing * * * *.
4. If, while entering a value (like an IP address), you decide to exit without entering any changes, you
may do so by pressing the * (star) key twice within a half second window of time. Otherwise, the
entry of the * (star) key will be treated as a dot (decimal point).
Example:
To enter an IP address, use numbers 0 – 9 on the telephone key pad. Use the * (star) key to enter a
decimal point.
To enter the following IP address value: 192.168.2.215
A. Use the touchtone key pad to enter: 192*168*2*215#
B. When prompted, enter 1 to save setting to configuration.
C. Hang-up the phone to cause setting to take effect.
- or -
D. Enter the value of the next setting category to modify . . .
5. Hang-up the phone to cause all settings to take effect.
3.2.2. SPA-2000 Interactive Voice Response (IVR) Menu:
IVR Action IVR Menu Choice Parameter(s) Notes:
Enter IVR Menu
* * * *
None Ignore SIT or other tones
until you hear, “Sipura
configuration menu.
Please enter option
followed by the pound key
or hang-up to exit.”
Check DHCP
100
None IVR will announce if DHCP
in enabled or disabled.