Filter
Top Products
© 2003 Sipura Technology, Inc Proprietary (See Copyright Notice on Page 2)
51
An “outside line” dial tone can be generated within a sequence by appending a ‘,’ character between
digits. Thus, the sequence “9, 1xxxxxxxxxx” sounds an “outside line” dial tone after the user presses
‘9’, until the ‘1’ is pressed.
Number Barring:
A sequence can be barred (rejected) by placing a ‘!’ character at the end of the sequence. Thus,
“1900xxxxxxx!” automatically rejects all 900 area code numbers from being dialed.
Interdigit Timer Master Override:
The long and short interdigit timers can be changed in the dial plan (affecting a specific line) by
preceding the entire plan with the following syntax:
• Long interdigit timer: ‘L’ ‘:’ delay-value ‘,’
• Short interdigit timer: ‘S’ ‘:’ delay-value ‘,’
Thus, “L=8,( . . . )” would set the interdigit long timeout to 8 seconds for the line associated with this
dial plan. And, “L:8,S:4,( . . . )” would override both the long and the short timeout values.
Local Timer Overrides:
The long and short timeout values can be changed for a particular sequence starting at a particular
point in the sequence. The syntax for long timer override is: ‘L’ delay-value ‘ ‘. Note the terminating
space character. The specified delay-value is measured in seconds. Similarly, to change the short
timer override, use: ‘S’ delay-value <space>.
Pause:
A sequence may require an explicit pause of some duration before continuing to dial digits, in order
for the sequence to match. The syntax for this is similar to the timer override syntax: ‘P’ delay-value
<space>. The delay-value is measured in seconds.
This syntax allows for the implementation of Hot-Line and Warm-Line services. To achieve this, one
sequence in the plan must start with a pause, with a 0 delay for a Hot Line, and a non-zero delay for a
Warm Line.
Implicit sequences:
The SPA-2000 implicitly appends the vertical code sequences entered in the Regional parameter
settings to the end of the dial plan for both line 1 and line 2. Likewise, if Enable_IP_Dialing is
enabled, then ip dialing is also accepted on the associated line.
Examples:
The following dial plan accepts only US-style 1 + area-code + local-number, with no restrictions on
the area code and number.
( 1 xxx xxxxxxx )