Filter
Top Products
© 2003 Sipura Technology, Inc Proprietary (See Copyright Notice on Page 2)
19
3.4. Configuration Parameters
3.4.1. System Parameters
System Configuration
Parameter Name Description Default
Admin Password The password for administrator
User Password The password for User
Enable Web Server Enable/disable web server of SPA
This feature should only be used on firmware version 1.0.9 or later.
Yes
Network Configuration
Parameter Name Description Default
DHCP Enable/Disable DHCP Yes
Host Name Host Name of SPA
Domain Name The network domain of SPA
Static IP Static IP address of SPA, which will take effect if DHCP is
disabled
0.0.0.0
NetMask The NetMask used by SPA when DHCP is disabled 255.255.255.
0
Gateway The default gateway used by SPA when DHCP is disabled 0.0.0.0
Primary DNS DNS server used by SPA in addition to DHCP supplied DNS
servers if DHCP is enabled; when DHCP is disabled, this will
be the primary DNS server.
0.0.0.0
Secondary DNS DNS server used by SPA in addition to DHCP supplied DNS
servers if DHCP is enabled; when DHCP is disabled, this will
be the secondary DNS server.
0.0.0.0
DNS Query Mode Do parallel or sequential DNS Query Parallel
Syslog Server Specify the syslog server name and port. This feature
specifies the server for logging SPA system information and
critical events.
Debug Server The debug server name and port. This feature specifies the
server for logging SPA debug information. The level of
detailed output depends on the debug level parameter
setting.
Debug Level The higher the debug level, the more debug information will
be generated. Zero (0) means no debug information will be
generated.
0
Notes:
- Parallel DNS query mode: SPA-2000 will send the same request to all the DNS servers at the
same time when doing a DNS lookup, the first incoming reply will be accepted by SPA-2000.
- To log SIP messages, Debug Level must be set to at least 2.
- If both Debug Server and Syslog Server are specified, syslog messages are also logged to the
Debug Server.
3.4.2. Provisioning Parameters
Provisioning operations are gated by the Provision_Enable parameter.
Parameter Name Description Default
Provision Enable Master enable for configuration profile resync operations Yes