Filter
Top Products
© 2003 Sipura Technology, Inc Proprietary (See Copyright Notice on Page 2)
5
This LED indicates status via the following behaviors:
ON – LED remains solid on
OFF – LED remains solid off
LONG (Long On) – 3.0s on, 1s off continuously
FAST – 0.125s on, 0.125s off continuously
SLOW – 0.5s on, 0.5s off continuously
VSLO (Very Slow) – 1.0s on, 1.0s off continuously
HB (Heart Beat) – 0.125s on, 0.125s off, 0.125s on, 1s off continuously
3. One Ethernet 10baseT RJ-45 Jack Interface (
Figure , above):
This interface accepts a standard or crossover Ethernet cable with standard RJ-45 connector. For
optimum performance, Sipura Technology recommends that a Category 5 cable or greater be used in
conjunction with the SPA-2000.
4. One LED for Data Link and Activity (
Figure , above):
This LED indicates status via the following behaviors:
ON – LED remains solid on
OFF – LED remains solid off
FAST – 0.125s on, 0.125s off continuously
SLOW – 0.5s on, 0.5s off continuously
Variable Blink – LED blinks according to packet traffic activity
5. One 5 Volt Power Adapter Interface (
Figure , above)
This interface accepts the SPA-2000 power adapter that came with the unit. Sipura Technology does
not support the use of any other power adapters other then the power adapter that was shipped with
the SPA-2000 unit.
1.1.1. Status LED Description:
The SPA-2000 Status LED is used to indicate the current operation status of the SPA unit. The state
is represented by a special blinking pattern of the Status LED (next to the RJ-11 ports on the right
side of the device). The below table describes the various modes and behaviors of the SPA-2000 in
relation to the Status LED and the handset behavior.
Status Description LED
Blink
Rate
Default Handset
Behavior
Normal Operation – Both Lines on hook OFF Normal
Normal Operation – Either line off hook ON Normal
Downloading new firmware SLOW Silent
Writing firmware to flash FAST Silent
Looking for DHCP Server SLOW Silent
No DHCP Server SLOW Silent
IP Address Conflict SLOW Silent