Filter
Top Products
© 2003 Sipura Technology, Inc Proprietary (See Copyright Notice on Page 2)
6
Unknown DHCP Error SLOW Silent
Note: The Link LED will blink on transmit and receive (TX/RX) of packets. The LED will display solid
off if no link is available. The LED will display solid on if link is up but no TX/RX activity is present.
Important Warning: Do not disrupt the power to the SPA-2000 while the Status LED is blinking FAST.
2. Installation Overview
Please check to make sure that you have the following package contents:
1. Sipura Phone Adapter Unit
2. Ethernet Cable
3. SPA-2000 QuickGuide
4. 5 Volt Power Adapter
You will also need:
1. One or Two Analog Touch Tone Telephones (or Fax Machine)
2. Access to an IP Network via an Ethernet Connection
Please observe the following steps to install the SPA-2000.
From the Left Side of the SPA-2000:
1. Insert a standard RJ-45 Ethernet cable (included) into the LAN port.
2. Insert the power adapter cable into the 5V power adapter cable receptacle.
Ensure that the power adapter jack is snugly attached to the SPA.
From the Right Side of the SPA-2000:
1. Insert a standard RJ-11 telephone cable into the Phone 1 port.
2. Connect the other end of the cable to an analog telephone or fax machine.
3. Insert a standard RJ-11 telephone cable into the Phone 2 port (Optional).
4. Connect the other end of the cable to an analog telephone or fax machine.
Note: Do not connect RJ-11 telephone cable from the SPA to the wall jack
to prevent any chance of connection to the circuit switched telco network.
You may now insert the plug end of the power adapter into a live power outlet which will power up the
SPA-2000.
3. Software Configuration
3.1.1.1. Firmware Upgrade
The SPA-2000 is firmware upgradeable via TFTP or via an executable PC program obtained from
Sipura Technology or an authorized distributor/reseller of Sipura Technology products.
Please contact the company from whom you purchased your SPA-2000 for access to Sipura
Technology firmware upgrades.
Firmware Upgrade via TFTP:
Firmware designed for TFTP upgrades are released as single binary files, which contain all the
modules pertaining to any one release version. By convention, the firmware loads are named with the
extension “.bin” (e.g. spa.bin)
The SPA-2000 can be configured to upgrade to a specific version, possibly staging through
intermediate releases, if necessary. This process can be automated for a pool of devices through
configuration profile parameters.