Configuring the SDC 8000 system
95
Assigning a channel to an audio output
Each of the audio outputs AUX OUT 3, AUX OUT 4 and AUX OUT 5 can be
assigned a channel. The maximum number of channels available depends
on your license. The configuration of two channels/languages is license-
free. In order to be able to configure more than two channels/languages,
you have to purchase one of the language licenses available (see
“Licenses” on page 103).
Note!
The floor channel is always assigned to the two outputs AUX OUT 1
(XLR-3M audio output) and AUX OUT 2 (9-pole sub-D socket). This
assignment cannot be changed!
To assign a channel:
̈ From the central unit’s operating menu, choose “
Aux-In/Out”.
̈ Choose one of the audio outputs AUX OUT 3 to AUX OUT 5.
̈ Choose “
Channel”.
The current channel number is shown on the display.
̈ Choose the desired channel number and press the ENTER key to save
your setting.
The desired channel is available at the selected audio output.
Turning the audio inputs or outputs on and off
To turn the audio outputs or inputs on and off:
̈ From the central unit’s operating menu, choose “
Aux-In/Out”.
̈ Choose the desired audio output or input.
̈ Choose “
Status”.
The current status (“
ON” or “OFF”) of the audio output or input is
shown on the display.
̈ Change the status and press the ENTER key to save your setting.
The selected audio output or input is turned on or off.
Configuring the audio outputs for remote conferencing
To prevent echo during remote conferencing:
̈ Make sure that the two central units of the conference systems
installed in separate rooms are connected correctly (see “Carrying out
remote conferences” on page 50).
̈ From the central unit’s operating menu, choose “
Aux-In/Out”.
̈ Choose the audio output “
1 & 2”.
̈ Choose “
Dist. Conf.”.
The current setting (“
Dist. Conf. = ON” or “Dist. Conf. = OFF”)
is shown on the display.
̈ To prevent echo, choose “
Dist. Conf. = ON” (if not yet chosen) and
press the ENTER key to save your setting.
Aux Out 3
2 Channel
Aux Out 3
Channel = 00
Press ENTER to Save
Aux Out 3
3 Status
Aux Out 3
Status = OFF
Press ENTER to Save
Aux Out 1 & 2
3 Dist. Conf.
Aux Out 1 & 2
Dist. Conf. = OFF
ENTER fuer Speichern