Filter
Top Products
Configuring the SDC 8000 system
90
Half-automatically initializing all interpreter consoles on the central unit
Once you have configured the number of interpreter booth (see “Setting
the max. number of interpreter booths/languages” on page 86) and the
number of interpreter consoles per booth (see “Setting the max. number
of interpreter consoles per booth” on page 86), you have to initialize all
interpreter consoles on the central unit as follows:
̈ From the central unit’s operating menu, choose “
Interpretation”,
“
Initialize Units” and “Full Init” one after the other.
The red signal light rings on all interpreter consoles start flashing and
the displays of the interpreter consoles show “
01” for both the booth
and the desk number.
1. If all of the interpreter consoles which were configured via the central
unit are connected, you can half-automatically initialize the
interpreter consoles, i.e. by pressing the MICRO key of an interpreter
console, this console is intialized on the central unit with the booth
and desk number shown on the console’s display.
̈ Start initializing the interpreter consoles by pressing the MICRO key of
interpreter console 1 in booth 1.
The red signal light ring of the interpreter console stops flashing. The
booth and desk numbers of all subsequent interpreter consoles are
automatically increased according to the preset number of booths and
the preset number of interpreter consoles per booth.
̈ Continue by pressing the MICRO key of interpreter console 2 in booth 1,
and so on.
̈ If all booth and desk numbers are assigned correctly, press the ENTER
key on the central unit to save this configuration.
The displays of the interpreter consoles show the languages assigned
to the A-channel and the B-channel and other related information (see
example illustration on the left).
The interpreter consoles are now ready for operation.
2. Alternatively, you can assign the booth and desk number of an
interpreter console individually (see “Manually assigning an
interpreter console an individual booth number” on page 90 and
“Manually assigning an interpreter console an individual desk number
(interpreter console number)” on page 91).
Manually assigning an interpreter console an individual booth number
To manually assign an interpreter console an individual booth number
(
BOOTH):
̈ From the central unit’s operating menu, choose “
Interpretation”,
“
Initialize Units” and “Full Init” one after the other.
Initialize Units
1 Full Init
Press Mic to confirm
BOOTH DESK
01 01
Full Init
Press ENTER to save
01 ENG
02 ARA
00 00 00 00
FLO FLO FLO FLO
Initialize Units
1 Full Init