Operating the components of the SDC 8000 system
34
Setting the channel to be output via the interpreter console’s built-in
loudspeaker
To set the channel (e.g. the floor channel or an interpretation channel) to
be output via the interpreter console’s built-in loudspeaker:
̈ Press the LS CHAN key ƽ and keep it pressed.
̈ While keeping the LS CHAN key pressed, press the “MENU ̆” or
“MENU ̄” menu selection key ƿ until the desired channel is shown on
the display.
Selecting an interpretation channel
To select an interpretation channel to be output via your headphones:
̈ Press one of the keys RELAY 1, RELAY 2 or RELAY 3 Ƽ and keep it
pressed.
̈ While keeping one of the keys RELAY 1, RELAY 2 or RELAY 3 pressed,
press the “MENU ̆” or “MENU ̄” menu selection key ƿ until the
desired language is shown on the display.
The pressed key RELAY 1, RELAY 2 or RELAY 3 is assigned the
interpretation channel with the selected language.
̈ To listen to the interpretation channel assigned to one of the keys
RELAY 1, RELAY 2 or RELAY 3, press the corresponding key Ƽ.
The LED next to the key lights up. The selected interpretation channel
is output via your headphones.
Using the interpreter console
As soon as your interpreter console is configured, you can use it as follows:
̈ Make sure that the correct channel for the target language is set (see
“Switching between the A-channel and the B-channel” on page 35):
y If you interpret into the main target language assigned to your
booth, choose the A-channel.
y If you interpret into a target language not assigned to your booth,
choose the B-channel.
In this case, make sure that the B-channel is configured to the
language into which you interpret (see “Configuring the B-channel of
an interpreter console” on page 33)!
y If you interpret a “rare” language into a language of which the other
interpreters have a complete understanding and from which they
then interpret into their respective languages (Auto-floor), also
choose the B-channel.
The green LEDs ¶ indicate the selected channel (A or B).
̈ Make sure that the selected channel is not being used!
The red “ENGAGED” LED ¾ of the selected channel must not light up!
̈ Press the MICRO key ƺ and start interpreting.
The red LED ¾ of the selected channel lights up.
̈ Press the MICRO key ƺ once more to stop interpreting.
The red LED ¾ of the selected channel goes off.
ƽ
ƿ
Ƽ
ƿ
¶
º
¾
¾
¶