Sennheiser SDC 8000 Conference Phone User Manual


 
Operating the components of the SDC 8000 system
30
̈ To cast your vote, press the corresponding key Ƽ below the display.
Your vote is counted. After the voting session, the result of the vote is
shown on the displays of the consoles.
Using the chip card slot of a conference console
If the conference consoles feature a chip card slot and if your system is PC
controlled, you can:
y make sure that only authorized delegates can participate in voting
sessions.
y take roll-call votes, i.e. you can see the name of each conference
participant and his or her voting position.
Operating the VIP units
VIP units are special delegate units which have the “rights” of a chairman
unit.
y With a VIP unit, you can take the floor at any time, regardless of the
conference mode and without first having to be assigned the “speaking
right”.
y If the chairperson presses the PRIOR. key, all active conference consoles
– except for the VIP units – are turned off. The chairperson cannot
withdraw the “speaking right” from you.
y The VIP units are operated in the same way as the elegate units.
Note:
In order to be able to configure VIP units, you require the software
control of the conference system.
Operating the chairman unit
Turning all active conference consoles off (priority)
All chairman units are equipped with a priority function, allowing the
chairman to stop a discussion any time. By using this function, all active
conference consoles are turned off.
To use the priority function:
̈ Press the PRIOR. key.
All active conference consoles – except for the VIP units – are turned
off.
Ƽ
¸