Filter
Top Products
Troubleshooting
74
General
Problem Cause & Remedy
The unit does not work. • Check the settings (p. 11–13).
• Check whether the dialing mode setting is
correct (p. 18).
• Charge the battery fully (p. 12).
• Clean the charge contacts and charge again
(p. 13).
• Install the battery properly (p. 12).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• The handset has not been registered to the
base unit. Register the handset (p. 67, steps
5 and 6).
• Re-install the battery (p. 12) and charge it
fully.
“Recharge battery” is
displayed, “” flashes
or the handset beeps
intermittently.
• Charge the battery fully (p. 12).
“Charge for 6 HRS” and
“” are displayed and the
handset does not work.
• The battery has been discharged. Charge the
battery fully (p. 13).
You charged the battery fully,
but “Recharge battery” is
still displayed and/or “”
continues to flash, or “Charge
for 6 HRS” and “” are
displayed.
• Clean the charge contacts and charge again
(p. 13)
.
• Install a new battery
(p. 12, 13)
.
The CHARGE indicator does
not go out after the battery
has been charged.
• This is normal.
If you cannot solve your
problem
• Call our customer call center at
1-800-211-PANA(7262).
• Panasonic’s e-mail address for customer
inquiries:
consumerproducts@panasonic.com
for customers in the USA or Puerto Rico
ONLY