Filter
Top Products
3-4 User Programming (Manager Programming)
3.1 User Programming Instructions
Before entering the programming mode
Before entering programming mode, confirm that:
• Your telephone is on-hook, and
• No calls are on hold at your telephone.
Entering the programming mode
To enter the User Programming (Manager Programming) mode:
Press PROGRAM + + + User Password (default:1234)
• The display shows the Initial Message:
USR-PGM NO?→
Note:
• If nothing is entered within five seconds after the PROGRAM button is pressed,
programming is canceled.
• During the programming mode, your extension is treated as a busy extension.
• Only one proprietary telephone can be in programming mode at any one time.
• The User Password is not shown on the display. The password can be changed by
System Programming.
Programming References
• System Programming — Installation Manual
[120] User Password
In this section, programs [000] through [004] are explained. Please consult with your
dealer when you need to change the following programs:
• [005] Flexible CO Button Assignment
• [006] Operator / Manager Extension Assignment
• [008] Absent Messages
• [009] Quick Dial Number Set