Filter
Top Products
4-22 DPT Features
C 4.2 DPT Features
• A floating extension such as a DISA (Direct Inward System Access) or external pager
cannot be programmed as a forwarding destination.
• Two extensions can set each other as the destination extension. In this case, an
intercom call to the other party while he/she is absent will not be forwarded back to the
original extension.
• Confirmation tone 2 (two beeps) is sent when the previously programmed data is same
as the new data. If it is not, confirmation tone 1 (one beep) is sent. Refer to the “Tone
List” in the Appendix (Section 7).
• A flexible button on the KX-T7250 (no FWD/DND button provided) can be assigned as
the FWD/DND button.
• You can call the original extension from the Call Forwarding destination extension.
(Boss Secretary)
• Both the Call Forwarding and Do Not Disturb (DND) functions can be set at the same
time, but cannot work at the same time.
• You can enable or disable the Call Forwarding or Do Not Disturb (DND) function by
pressing the FWD/DND button while on-hook. If you set both Call Forwarding and
DND, alternating the mode is also available by pressing the FWD/DND button. In this
case, pressing the button changes the setting as follows:
the most recent setting
→ the other setting → off
The lighting patterns of the FWD/DND button are as follows:
Off : Both functions are not set
Red : DND mode
Flashing red slowly: FWD mode
• With the KX-T7436 and KX-T7235, you can set or cancel the Call Forwarding features
using the display operation.
Programming References
• Station Programming (Section 2)
Flexible CO Button Assignment — FWD/DND Button
(System Programming — [005] (Installation Manual) can be used for this assignment.)
Feature References
Call Forwarding — CANCEL
Call Forwarding / Do Not Disturb (4.4/Special Display Features)
Do Not Disturb (DND)
Voice Mail Integration