Filter
Top Products
DPT Features 4-43
4.2 DPT Features C
Call Transfer using a DSS (Direct Station Selection) button
Allows you to perform a Screened or Unscreened Call Transfer by using a DSS button.
There are two operations, depending on whether or not One-Touch Transfer* is set.
* One-Touch Transfer allows you to hold an outside call and transfer it to an extension by pressing one
key. This feature provides automatic hold and transfer, without pressing the TRANSFER button.
System Programming is required to use this function.
“One-Touch Transfer” mode enabled:
During a conversation;
1. Press the desired flexible button which is assigned as the DSS
button.
• The other party is placed on hold and the destination
extension is called immediately.
“One-Touch Transfer” mode disabled:
During a conversation;
1. Press the TRANSFER button.
2. Press the desired flexible button which is assigned as the DSS
button.
Conditions
• If you misdial, press the FLASH or FLASH/RCL button, and re-enter the number.
• If you want to return to the held call, press the TRANSFER button or corresponding
CO or INTERCOM button before the destination extension answers.
• If the destination extension does not answer the call within twelve rings (default),
“Transfer Recall” occurs. If the transferred call is an outside call, it is possible to select
whether Transfer Recall will go to the initiating extension or to Operator 1 by System
Programming.
• When “Transfer Recall” occurs, the display shows:
<Example>
• If there is no answer for thirty minutes after “Transfer Recall” starts, the line will be
disconnected.
• A flexible CO button can be assigned as a DSS button.
• To use “One-Touch Transfer”, System Programming is required.
1
1
2
TRANSFER
RCL: Ext 13