Panasonic KX-TD308 Telephone User Manual


 
2-2 Station Programming (Personal Programming)
2.1 Station Programming Instructions
Station Programming allows you, the proprietary telephone (PT) users, to program certain
features from your telephone individually. To program, you need to switch your
telephone to the Station Programming mode. During programming mode, your telephone
is in the busy condition to outside callers. If you want to make a normal call handling
operation, you must finish the programming mode.
Programming Mode Display
When you enter the Station Programming mode, the display shows the following message
as the initial programming mode;
The display also gives you helpful or stored data information related to your
programming steps. In this section, we note the display example in the programming
steps, if required. You can also refer to the “Display Examples” in the Appendix
(Section 8).
To enter the Station Programming mode
Be sure the telephone is idle and on-hook.
1. Press the PROGRAM button.
2. Dial 99.
If 99 is not dialed within 5 seconds of pressing the
PROGRAM button, the Station Programming mode is
canceled.
The display shows:
(— initial programming
display)
The STORE indicator lights.
If there is no entry within one minute, the Station
Programming mode is canceled. Normal call handling
resumes.
To exit the Station Programming mode
When the display shows the initial programming mode;
1. Press the PROGRAM button or lift the handset.
Programming is completed and normal call handling
resumes.
If you go off-hook while programming, the mode is canceled
and normal call handling resumes.
1
2
1
or
9
PROGRAM
PROGRAM
PT-PGM Mode
PT-PGM Mode
9