Filter
Top Products
Useful InformationAnswering System
Preparation
91
Canceling Registration/Re-registration
Telephone System
For assistance, please call: 1-800-211-PANA(7262)
• You can stop registration by pressing [OFF] on the handset and pressing
[LOCATOR/INTERCOM/TRANSFER] on the base unit.
• If “Wrong handset Refer to manual” is displayed, the handset you tried to
register is not for this base unit. This handset is for KX-TG5200/KX-TG5202/
KX-TG5210/KX-TG5212/KX-TG5230/KX-TG5240/KX-TG5243/KX-FPG391 base
unit. The accessory handset for this base unit is KX-TGA650. To order, see
page 3.
If you have canceled handset registration at a previous base unit (p. 90), start
from step 5.
1 Handset: Press [MENU].
2 Handset: Scroll to “Initial setting” by
pressing [d] or [B], then press the soft key
().
3 Handset: Scroll to “Registration” by
pressing [d] or [B], then press the soft key
().
4 Handset: Press the soft key ( ) at “HS
registration”.
5 Base unit:
Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing,
the rest of the procedure must be completed within 1 minute.
6 Handset:
(1) Press the soft key ( ).
(2) Wait until a long beep sounds and the
display shows the new extension number
(ex. extension number 2).
• Registration is complete.
If you have not canceled the handset’s registration at the previous base unit
(p. 90), the handset number remains in that base unit’s memory. To erase the
handset number from the previous base unit, perform the following steps:
(1) Press and hold [LOCATOR/INTERCOM/TRANSFER] for 3 seconds, and (2)
Press and hold the handset number [1]
() to
[4]
()
that you do not want for 5
seconds. A long beep sounds, then the handset number is erased from the base
unit memory.
SELECT
Initial setting
SELECT
Registration
SELECT
HS registration
OK
Press LOCATOR
on base unit
for 3 sec.
Then press OK
OK
SP
I
PRIVACY
1
Handset [2]
Registered
IN USE
[
2
]
TG6500.book Page 91 Friday, June 25, 2004 6:56 PM