Filter
Top Products
Room Monitor
64
To monitor with
The unit to be monitored must not be in use and the handset to be monitored
must be off the base unit.
• The monitored user can stop being monitored by:
— on the handset, press [OFF] or place the handset on the base unit.
— on the base unit, press [LOCATOR/INTERCOM/TRANSFER] or
[SP-PHONE].
• “Room monitor” is also displayed on the monitored handset.
• While the base unit is monitoring or being monitored, the LOCATOR/INTERCOM/
TRANSFER indicator light flashes and the SP-PHONE indicator lights.
• If an incoming call is being received, you will hear 2 tones (incoming call tone,
p. 68). To answer the call, press the called line soft key ( ) or ( ).
To monitor with
The handset to be monitored must not be in use and off the base unit.
• If the Room Monitor feature of the destination handset is off or the handset is on
the base unit, busy tones will sound.
• If an incoming call is being received, you will hear 2 tones (incoming call tone,
p. 68) and the line button will flash rapidly. To answer the call, press the called line
button.
1 Press [HOLD/INTERCOM], then press the soft key ( ).
2 To call the base unit, press [0].
To call another handset, press its extension
number ([1] to [4]).
• To monitor from the speaker, press [s]. If the
handset is placed on the base unit, monitoring
will be stopped. You can place the handset on
the charger and continue monitoring. To switch
back to the receiver, press
[C].
3 To end monitoring, press [OFF].
1 Press [LOCATOR/INTERCOM/TRANSFER], then press [MUTE].
• The SP-PHONE indicator lights and the LOCATOR/INTERCOM/TRANSFER
indicator flashes.
2 To call the handset, press its extension number [1]
( ) to
[4]
()
.
3 To end monitoring, press [LOCATOR/INTERCOM/TRANSFER] or
[SP-PHONE].
• The indicator lights go out.
Handset
MONITOR
Press extension#
for room monitor
1-4=Handset
0=Base
Room monitor
00-00-05
D01
LINE1 LINE2
Base Unit
TG6500.book Page 64 Friday, June 25, 2004 6:56 PM