Filter
Top Products
Useful InformationAnswering SystemTelephone System
25
Programmable Settings
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Temporary ringer off
While the handset is ringing, you can turn the ringer off temporarily by pressing
[OFF]. The handset will ring again the next time a call is received for that line.
Base unit ringer volume (use either the base unit or the handset)
Make sure the base unit is not being used.
To turn the ringer on, press [d] or [B] in step 2.
• The base unit will ring at the low level for the line.
• You can adjust the base unit ringer volume while the line is ringing.
Press
[d] or [B] while the line is ringing.
To turn the ringer off, press and hold [d] until 2 beeps sound. “ ” or “ ” is
displayed.
Selecting the base unit ringer volume by using the
1 Select either line by pressing [LINE SELECT]
until “LINE 1” or “LINE 2” is announced.
• The selected line ( or ) is displayed.
• Do not select both lines. You can not set the
ringer for both lines at the same time.
2 To set the ringer volume to high (preset), medium, or low, press
[d] or [B].
• To increase volume, press [B]. To decrease volume, press [d]
.
• To change the ringer tone, press [H] or [G] (p. 27).
• To stop ringing, press [STOP].
To turn the ringer off, press and hold [d] until 2 beeps sound.
• “ ” or “ ” is displayed.
1
Press
[MENU]
.
2 Scroll to “Initial setting” by pressing [d] or [B], then press the
soft key ( ).
3 Scroll to “Set base unit” by pressing [d] or [B], then press the
soft key ( ).
4 Press the soft key ( ) at “Ringer volume”.
5 Follow steps 4 to 7 of “Handset ringer volume” on page 24.
• When selecting the ringer volume, the base unit will ring.
Base Unit
LINE 1 LINE 2
LINE
LINE
1
Ex. LINE 1 selected.
L 1
L 2
L 1
L 2
Handset
SELECT
SELECT
SELECT
TG6500.book Page 25 Friday, June 25, 2004 6:56 PM