Filter
Top Products
Useful InformationAnswering SystemTelephone System
31
Preparing the Answering System
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Number of Rings
You can select the number of times the unit rings before the Answering System
answers a call, from “2” to “7” or “Toll saver”*. Each line has its own setting. The
factory preset for both lines is “4”.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing
[d] or [B], then press the soft key ( ).
3 Press the soft key ( ) at “Set
answering”.
4 Press the soft key ( ) at “Number of
rings”.
5 Press [d] (Line1) or [B] (Line2) to select
the line.
6 Select the number of rings by pressing [d]
or [B].
• You can also select the number of rings by
pressing [0] (Toll saver*), or [2] to [7].
7 Press the soft key ( ).
• To select the other line, repeat from step 4.
8 Press [OFF].
*Toll saver
When you call a line to which “Toll saver” has been set, from a remote location,
the number of rings will tell you if there are any new messages. If the unit
answers on the 2nd ring, there is at least 1 new message. If the unit answers on
the 4th ring, there are no new messages. To save the toll charges for the call,
hang up immediately when you hear the 3rd ring. The 3rd ring indicates that
there are no new messages.
Handset
SELECT
Initial setting
SELECT
Set answering
SELECT
Number of rings
Number of rings
d
=Line1
B
=Line2
Number of rings
Line1:4
SAVE
TG6500.book Page 31 Friday, June 25, 2004 6:56 PM