Filter
Top Products
2. Setting Up Your Phone
40 DBS 576 (USA), issued October 2000 576-36-750
To set the Special Day Modes using either a large-display
or small-display phone:
To set the Message Key ID code using either a large-
display or small-display phone:
1. Enter “User Maintenance” by pressing: ON/OFF PROG * * CONF
2. Enter:
07, press HOLD, enter: 1, and press HOLD HOLD.
3. Enter:
Start Time in Hours - 2 characters, and Minutes - 2
characters
for the Special Day 1 mode and press HOLD to store the
entry.
Note: To clear an entry or existing data, press the FLASH key.
4. Enter: Desired mode for Special Day: 0 - None, 1 - Day 1, 2
- Day 2, 3 - Night, 4 Night 1, 5 - Night 2
and press HOLD to store
the entry.
Note: To clear an entry or existing data, press the FLASH key
5. To set additional Special Day modes, press the VOLUME up or down arrow
or HOLD to move to the desired mode.
6. Repeat steps 3-5 until all Special Day modes are set. (Up to 20 Special Days
may be entered.).
Note: The entry positions are listed in Chapter 4 of Section 700 - Feature Operations.
7. Press AUTO PROG to return to “81-User Maintenance” (step 1 above).
OR...
Press
AUTO ON/OFF to exit User Maintenance.
1. Enter “User Maintenance” by pressing:
ON/OFF PROG * * CONF
2. Enter:
06 and press HOLD HOLD.
3. Dial the
Extension Number of the Phone Being
Programmed
and press HOLD.
4. Enter:
Message Key ID Code and press HOLD to store the entry.
Note: The ID code may contain up to 16 digits and contain 0, 1-9, *, #, pause (REDIAL
key).
• To clear an entry or existing data, press the FLASH key.
Message Key