Filter
Top Products
2. Setting Up Your Phone
576-36-750 DBS 576 (USA), issued October 2000 29
1. Pick up the handset or press the ON/OFF key.
2. Either:
• Press the PROG key and then press the AUTO key.
OR
• Enter the Speed Dial Set/Clear code (default = 710).
3. Press the soft or one-touch key (for the PSD bin [80-99]) to be programmed.
4. Press the AUTO key.
5. Enter the SSD bin number that contains the first part of the number to be dialed.
(If a pause is required, press the REDIAL key.)
6. Repeat steps 4-5 (up to 5 more times) for each remaining SSD number to be
linked.
7. Press the HOLD key when you are finished.
8. Replace the handset or press the ON/OFF key.
1. If necessary, select the trunk group (9, 81-84) to access an outside line. (Normally
the trunk is selected by the speed dial numbers.)
2. Press the PSD key.
Assigning and Deleting Names for PSD Numbers
After assigning a PSD number to a one-touch or soft key, you can assign a name to
the key (e.g., “Home,” “John,” etc.). You can then view the assigned PSD name
when you are in the PSD Directory mode.
Note: You need to know the PSD bin number for PSD number in order to assign a
name to it. To determine the bin number, see “Checking Speed Dial Numbers” on
page 54.
Note: This task requires a display phone.
1. Pick up the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the * key.
To use a PSD key that links multiple speed dial numbers
To assign a name to a PSD number