Filter
Top Products
CHAPTER 2 INSTALLATION
Installation for Main Site
NEAX2000 IVS
2
Remote PIM System Manual
ND-70917 (E), Issue 1.0
Page 25
Figure 2-4 BUS Cable Connection (2 of 2)
(b) When mounting DAIA/DAID card on PIM2, PIM4
When Main PIM is 5 or 6 PIM configuration, the DAIA/DAID card must be mounted
on PIM2 and/or PIM4, and connected as follows:
RMT BUS CA-A
5 PIM
6 PIM
NOTE: DAIA/DAID card must be mounted in even-numbered PIMs. When mounted in
PIM0 BWB BUS connector, BUS1B or BUS0B may be used for this connection.
When mounted in PIM2 or PIM4 BWB BUS connector, BUS1B must be used.
BUS1B
BUS1A
BUS0B
BUS0A
DAIA/
DAID
PCM1
PCM0
PIM2/
PIM4
PIM2
PIM4
PIM2
PIM4
NOTE