Filter
Top Products
CHAPTER 2 INSTALLATION
Installation Procedure
NEAX2000 IVS
2
Remote PIM System Manual
ND-70917 (E), Issue 1.0
Page 21
INSTALLATION PROCEDURE
Install the Remote PIM System according to the following procedure.
Installation Procedure for Main Site
Figure 2-2 shows a flowchart of the installation procedure for the Main Site.
Figure 2-2 Installation Procedure for Main Site
DAI Connection at Main Site
BUS Cable Connection
START
NOTE 1: This procedure is required even if the Main Site is 1-PIM/2-PIM configuration.
NOTE 2: This procedure is required when providing PN-M10 card to connect an optical
interface.
Mounting FP Card
Mounting M10 Card
Optical Cable Connection
See Page 23.
See Page 23.
See Page 23.
See Page 24.
See Page 51.
See Page 47.
See Page 23.
Mounting DAIA Card for T1 /
DAID Card for E1
Mounting DAIC Card for T1 /
DAIF Card for E1
END
See Page 55.
MP Reset
NOTE 1
NOTE 2