Filter
Top Products
NEAX2000 IVS
2
Remote PIM System Manual
Page 24 ND-70917 (E), Issue 1.0
CHAPTER 2 INSTALLATION
Installation for Main Site
BUS Cable Connection
(1) Cable Connection Between BUS Connector on the BWB and DAIA/DAID Card
Connect the DAIA/DAID card to the BUS connector on the BWB by the RMT BUS CA-A, as
shown in Figure 2-4.
In BUS connector on the BWB, BUS1B or BUS0B of the even-numbered PIMs (PIM0, 2, 4,
etc.) must be used for this connection.
Figure 2-4 BUS Cable Connection (1 of 2)
(a) When mounting DAIA/DAID card on PIM0
• When Main PIM is 1 or 2 PIM configuration
• When Main PIM is 3 or 4 PIM configuration
NOTE
1 PIM
2 PIM
3 PIM
4 PIM
BUS1B
BUS1A
BUS0B
BUS0A
BUS1B
BUS1A
DAIA/
DAID
DAIA/
DAID
BUS0B
BUS0A
PCM1
PCM0
PIM0
PCM1
PCM0
PIM0
RMT BUS CA-A
RMT BUS CA-A
NOTE
PIM0
PIM0
PIM2
PIM2
PIM0
PIM0
NOTE: DAIA/DAID card must be mounted in even-numbered PIMs. When mounted in
PIM0 BWB BUS connector, BUS1B or BUS0B may be used for this connection.
When mounted in PIM2 or PIM4 BWB BUS connector, BUS1B must be used.