Filter
Top Products
CHAPTER 2 INSTALLATION
Installation for Main Site
NEAX2000 IVS
2
Remote PIM System Manual
ND-70917 (E), Issue 1.0
Page 23
INSTALLATION FOR MAIN SITE
Mounting DAIA Card for T1 / DAID Card for E1
(1) Before mounting the DAIA/DAID card, set the MB switch to UP position,
and set the other switches to appropriate position. See CHAPTER 4.
(2) Mount the DAIA/DAID card in the AP slots (AP00-AP11) on the Main Site PIM0, 2, 4.
A maximum of three DAIA/DAID cards can be mounted.
After mounting the card, set the MB switch to DOWN position.
Mounting DAIC Card for T1 / DAIF Card for E1
(1) Before mounting the DAIC/DAIF card, set the MB switch to UP position, and set the other
switches to appropriate position. See CHAPTER 4.
(2) Mount the DAIC/DAIF card in the AP slots (AP00-AP11) on the Main Site PIM0, 2, 4.
A maximum of six DAIC cards can be mounted.
A maximum of three DAIF cards can be mounted.
After mounting the card, set MB switch to DOWN position.
(3) After mounting all DAIC/DAIF cards, set MB switch on DAIA/DAID card to UP, and then
DOWN.
Mounting FP Card
(1) Before mounting the FP card, set the MB switch to UP position, and set the other switches
to appropriate position. See CHAPTER 4.
(2) Mount the FP card in the FP slot of PIM0, PIM2, PIM4 and PIM6.
After mounting the card, set MB switch to DOWN position.
Mounting M10 Card
(1) Confirm the correct switch settings. See CHAPTER 4.
(2) Mount the M10 card in any one of LT slot on each PIM.
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required