Filter
Top Products
5-24
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 5 Parameters and Defaults
Operational Parameters
Range
-9 to 2 dB
Default
-4
Voice Configuration Menu Access Code
371
Related Parameter
FXSInputLevel, page 5-23
ConnectMode
Description
This parameter is a 32-bit bitmap to control the connection mode of the selected call signaling protocol.
Table 5-2 provides bit definitions for this parameter.
Value Type
Bitmap
Default
0x90000400
Voice Configuration Menu Access Code
311
Table 5-2 ConnectMode Parameter Bit Definitions
Bit Number Definition
0-1 Reserved.
2 0—Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
1—Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
Default: 0
3-6 Reserved.
7 0/1—Disable/enable fax pass-through redundancy.
Default: 0
8-12 Specifiy the fax pass-through NSE payload type with these bits. The value is the offset to the NSE payload
base number of 96. The valid range is 0-23; the default is 4.
For example, if the offset is 4, the NSE payload type is 100.