Filter
Top Products
CHAPTER
5-1
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
5
Parameters and Defaults
This section provides information on the parameters and defaults that you can use to create your own
Cisco ATA configuration file. This section also includes the voice configuration menu code for each
parameter that has such a code.
Parameters are divided into categories based on their functionality. The following categories of
parameters are covered in this section:
• User Interface (UI) Security Parameter, page 5-3
• Parameters for Configuration Method and Encryption, page 5-4
• Network Configuration Parameters, page 5-8
• MGCP Configuration Parameters, page 5-12
• Audio Configuration Parameters, page 5-19
• Operational Parameters, page 5-21
• Tone Configuration Parameters, page 5-29
• Diagnostic Parameters, page 5-40
• CFGID—Version Parameter for Cisco ATA Configuration File, page 5-43
The following list contains general configuration information:
• Your configuration file must begin with #txt.
• The Cisco ATA uses the following parameter types:
–
Alphanumeric string
–
Array of short integers separated by commas
–
Boolean (1 or 0)
–
Bitmap value—unsigned hexadecimal integer (for specifying bits in a 32-bit integer)
Note Bits are numbered from right to left, starting with bit 0.
Note A tool called bitaid.exe is bundled with your Cisco ATA software. You can use this tool
to help you configure values of Cisco ATA bitmap parameters. The tool prompts you
for the necessary information.
–
Extended IP address—IP address followed by port number (for example, 192.168.2.170.9001)