Filter
Top Products
7-3
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 7 Upgrading the Cisco ATA Signaling Image
Upgrading the Signaling Image Manually
Preliminary Steps
Before you run the executable file, be sure to complete the following procedure:
Procedure
Step 1 If you are a registered CCO user. go to the following URL:
http://www.cisco.com/cgi-bin/tablebuild.pl/ata186
Step 2 Locate the zip file that contains the software for the applicable release and signaling image you are
using. The contents of each file are described next to the file name. Extract the signaling image file (this
file has an extension of .zup—For example, ata186-v2-15-020723a.zup) and store it on the PC that has
connectivity with the Cisco ATA.
Step 3 Set the Cisco ATA parameter UseTftp to 0.
Note Remember to set this parameter back to 1 before you use the TFTP upgrade method at a later
time.
Step 4 Follow the instructions in the “Running the Executable File” section on page 7-3.
Running the Executable File
This section includes the procedure for running the executable file and using the voice configuration
menu to complete the upgrade process. First check to make sure the upgrade requirements are met and
determine the syntax to use when running the program.
This section contains the following topics:
• “Upgrade Requirements” section on page 7-3
• “Syntax” section on page 7-3
• “Upgrade Procedure” section on page 7-4
Upgrade Requirements
The following list contains the requirements for using the ata186us.exe file and the voice configuration
menu to upgrade the Cisco ATA to the latest signaling image:
• A network connection between the PC from which you will invoke the executable file and the
Cisco ATA
• A PC running Microsoft Windows 9X/ME/NT/2000
Syntax
ata186us [-any] {-h[host_ip]} {-p[port]} {-quiet} [-d1 -d2 -d3] <image file>