Cisco Systems 7940 IP Phone User Manual


 
1-5
Cisco IP Phone 7960 and 7940 Series User Guide
78-10182-08
Chapter 1 Introducing Your Cisco IP Phone
Auto-Registering Your Phone Using TAPS
Related Topics
Auto-Registering Your Phone Using TAPS, page 1-5
A Road Map to Your Cisco IP Phone, page 1-6
Using the Handset, Headset, and Speakerphone, page 1-12
Auto-Registering Your Phone Using TAPS
Your administrator may ask you to auto-register your Cisco IP Phone using TAPS,
the Tool for Auto-Registered Phones Support. TAPS might be used either for a
new phone or to replace an existing phone.
Note You should follow this procedure only if your phone administrator asks you to.
Procedure
Step 1 If the phone is not already installed, follow the installation instructions available
in the
“Connecting Your Cisco IP Phone” section on page 1-2.
After you plug the phone into a port, the phone automatically registers and
displays a number.
Step 2 Dial the TAPS extension provided by your system administrator.
Step 3 A voice prompt asks you to select the language that you want to use. Choose
appropriately.
Step 4 Dial your personal extension number (provided by your system administrator),
then press the # key.
Note You may be instructed to enter the complete telephone number (including
area code).