Filter
Top Products
7-2
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23874-01
Chapter 7 Troubleshooting and Maintenance
Resolving Startup Problems
Symptom: The Cisco Unified IP Phone Does Not Go Through its Normal Startup
Process
When you connect a Cisco Unified IP Phone into the network port, the phone should go through its
normal startup process as described in
“Verifying the Phone Startup Process” section on page 3-9. If the
phone does not go through the startup process, the cause may be faulty cables, bad connections, network
outages, lack of power, and so on. Or, the phone may not be functional.
To determine whether the phone is functional, follow these suggestions to systematically eliminate these
other potential problems:
1. Verify that the network port is functional:
–
Exchange the Ethernet cables with cables that you know are functional.
–
Disconnect a functioning Cisco Unified IP Phone from another port and connect it to this
network port to verify the port is active.
–
Connect the Cisco Unified IP Phone that will not start up to a different network port that is
known to be good.
–
Connect the Cisco Unified IP Phone that will not start up directly to the port on the switch,
eliminating the patch panel connection in the office.
2. Verify that the phone is receiving power:
–
If you are using external power, verify that the electrical outlet is functional.
–
If you are using in-line power, use the external power supply instead.
–
If you are using the external power supply, switch with a unit that you know to be functional.
3. If the phone still does not start up properly, perform a factory reset of the phone. For instructions,
see the
“Performing a Factory Reset” section on page 7-10.
If after attempting these solutions, the phone still does not function, contact a Cisco technical support
representative for additional assistance.
Symptom: The Cisco Unified IP Phone Does Not Register with Cisco Unified
Communications Manager
If the phone proceeds past the first stage of the startup process (all LED buttons on) but the phone is not
starting up properly. The phone cannot successfully start up unless it is connected to the Ethernet
network and it has registered with a Cisco
Unified Communications Manager server.
These sections can assist you in determining the reason the phone is unable to start up properly:
• Identifying Error Messages, page 7-3
• Checking Network Connectivity, page 7-3
• Verifying TFTP Server Settings, page 7-3
• Verifying IP Addressing and Routing, page 7-3
• Cisco CallManager and TFTP Services Are Not Running, page 7-4
• Creating a New Configuration File, page 7-4
• Checking Network Connectivity, page 7-3