Filter
Top Products
2-8
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23874-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified Communications Manager Database
These sections describe the methods:
• Adding Phones with Auto-Registration, page 2-8
• Adding Phones with Auto-Registration and TAPS, page 2-9
• Adding Phones with Cisco Unified Communications Manager Administration, page 2-10
• Adding Phones Using the BAT Phone Template, page 2-10
Table 2-4 provides an overview of these methods for adding phones to the Cisco Unified
Communications Manager database.
Adding Phones with Auto-Registration
By enabling auto-registration before you begin installing phones, you can:
• Add phones without first gathering MAC addresses from the phones.
• Automatically add a Cisco Unified IP Phone to the Cisco Unified Communications Manager
database when you physically connect the phone to your IP telephony network. During
auto-registration, Cisco
Unified Communications Manager assigns the next available sequential
directory number to the phone.
• Quickly enter phones into the Cisco Unified Communications Manager database and modify any
settings, such as the directory numbers, from Cisco
Unified Communications Manager.
• Move auto-registered phones to new locations and assign them to different device pools without
affecting their directory numbers.
Note Cisco recommends you use auto-registration to add less than 100 phones to your network. To add more
than 100 phones to your network, use the Bulk Administration Tool (BAT). See the
“Adding Phones
Using the BAT Phone Template” section on page 2-10.
Ta b l e 2-4 Methods for Adding Phones to the Cisco Unified Communications Manager
Database
Method
Requires MAC
Address?
Notes
Auto-registration No • Results in automatic assignment of directory
numbers
• Not available when security or encryption is enabled.
Auto-registration with
TAPS
No Requires auto-registration and the Bulk Administration
Tool (BAT); updates information in the Cisco Unified IP
Phone and in Cisco Unified
Communications Manager
Administration
Using the Cisco Unified
Communications
Manager Administration
Yes Requires phones to be added individually
Using BAT Yes Allows for simultaneous registration of multiple phones