Filter
Top Products
E-7
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23874-01
Appendix E Installing the Wall Mount for the Cisco Unified IP Phone 6901 and 6911
Installing a Wall Mount for the Cisco Unified IP Phone 6911
Installing a Wall Mount for the Cisco Unified IP Phone 6911
The following section describes how to install the wall mount for use with the Cisco Unified IP Phone
6911.
Figure E-7 shows a list of items included in the Wall Mount Kit for the Cisco Unified IP Phone 6911.
Figure E-7 Wall Mount Kit for Cisco Unified IP Phone 6911
The package includes the following items:
• One phone bracket
• One wall bracket
• Four 10-12x1 inch Phillips-head screws with 4 anchors
• Two 4-40x1/4 inch machine screws
• One six-inch Ethernet cable
• One key if the bracket includes the optional lock
Before You Begin
You will need these tools to install the bracket:
• #1 and #2 Phillips-head screwdrivers
• Level
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does
not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a
regular telephone jack. For more information on phone installation requirements and warnings, see the
Setting Up the Cisco Unified IP Phone chapter.
Screws
(4)
Anchors
(4)
Machine
screws
(2)
Ethernet
cable
Lock-down
key
Wall bracketPhone bracket
274935