Filter
Top Products
DHCP
Issue 2.2 April 2005 61
8. Change the Data Type to String.
9. In the Code field, enter 176, then click the OK button twice.
The Predefined Options and Values dialog box closes, leaving the DHCP dialog box
enabled.
10. Expand the newly created scope to reveal its Scope Options.
11. Click Scope Options and select Action
-->Configure Options from the menu.
12. In the General tab page, under the Available Options, check the Option 176 checkbox.
13. In the Data Entry box, enter the DHCP IP telephone option string as described in DHCP
Generic Setup on page 50.
Note:
Note: You can enter the text string directly on the right side of the Data Entry box under
the ASCII label.
14. From the list in Available Options, check option 003 Router.
15. Enter the gateway (router) IP Address from the IP Address field of Table 2: Required
Network Information Before Installation - Per DHCP Server.
16. Click the Add button.
17. Click the OK button.
Activating the New Scope
Use the following procedure to activate the new scope.
1. In the DHCP console tree, click the IP Telephone Scope you just created.
2. From the Action menu, select Activate.
The small red down arrow over the scope icon disappears, indicating that the scope was
activated.