Filter
Top Products
AT&T
Door Phone Controller
— Option Selection
To Select Options: (1) Set DIP switch location 8 to the ON position. (2) Dial door speaker phone number or
extension. (3) Dial ##3. (4) Program any or all of the following functions, in any order:
Mode Option/
Listen
Listen
Options
Verify
Press
Press
For
For
Default
Delay Before
To Select Option
00
Single 000 to 255 for 0 to 255 Double 30 sec.
Door Ajar
Beep seconds of delay after strike
Beep
Call-back
To Verify
01
plate release stops until
Door Phone Controller calls
back to indicate that door is
ajar
Ring/Chime To Select Option
10
Single 24 (for 2 sec. on 4 sec. off
Double
2 sec./
Cadence
Beep
cadence)
or
Beep
4 sec.
To Verify
11 15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime To Select Option 20
Single 00 to 99 (0 to 99 second(s)
Double 30 sec.
Duration
Beep
ring/chime)
Beep
To Verify 21
Door Unlock
To Select Option 30 Single 4 digits (first digit must be
Double
6736
Code
Beep 0,3,4,5,6,7 or 8;
Beep
“OPEN”
To Verify 31
remaining digits can be set
from 0 to 9)
Door Unlock
To Select Option 40
Single 00 to 99 (door lock active
Double
4 sec.
Duration
Beep
time in sec.)
Beep
To Verify
41
Enable Door To Select Option 50
Single
1
Enable door code Double
1
Code
Beep
0 Disable door code
Beep
(Enabled)
To Verify 51
Door Ajar
To Select Option
50
Single
2
For callback after strike
Double
2
Mode
Beep
plate release only Beep
To Verify
51
3
For callback anytime
door is opened
Forced To Select Option 60
Single 010 to 255 (unit disconnects Double 120 sec.
Disconnect
Beep in 10 to 255 sec.) Beep
Time-Out
To Verify
61
Reset Options To Select Option
70
Single ## (to restore factory default Double N/A
to Factory
Beep conditions)
Beep
Defaults
To Verify
71
Phone
To Select Option
80
Single 0 to 20 numerical digits and Double
#
Number
Beep ❊ ( ❊ = 2 second pause) #
Beep
Storage
To Verify 81
terminates entry
Memory 1
Phone
To Select Option 90 Single 0 to 20 numerical digits and Double
#
Number
Beep ❊ ( ❊ = 2 second pause) #
Beep
Storage
To Verify 91 terminates entry
Memory 2
After Selecting Options: (1) Press ##3. (2) Hang up after hearing a double beep confirmation. (3) Set DIP
location 8 back to the OFF position, to prevent unauthorized re-programming. (See other side for DIP Switch Settings.)