Filter
Top Products
Operation –
Basic Door Answer Function
Table 4-1. AT&T Door Phone Controller Option Selection Information
Mode Option/
Listen
Listen
Options
Verify
Press
For
Press
For
Default
Delay Before To Select Option
00
Single 000 to 255 for 0 to 255
Double 30 sec.
Door Ajar
Beep seconds of delay after strike
Beep
Call-back
To Verify
01
plate release stops until
AT&T Door Phone Controller
calls back to indicate that
door is ajar
Ring/Chime To Select Option
10
Single 24 (for 2 sec. on 4 sec. off
Double
2 sec./
Cadence
Beep cadence)
or
Beep 4 sec.
To Verify
11
15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime To Select Option
20
Single 00 to 99 (0 to 99 second(s)
Double 30 sec.
Duration
Beep
ring/chime)
Beep
To Verify
21
Door Unlock To Select Option
30
Single 4 digits (first digit must be
Double 6736
Code
Beep 0,3,4,5,6,7 or 8
Beep “OPEN”
To Verify
31 remaining digits can be set
from 0 to 9)
Door Unlock To Select Option
40
Single
00 to 99 (door lock active
Double
4 sec.
Duration
Beep time in sec.)
Beep
To Verify
41
Enable Door To Select Option
50
Single 1
Enable door code Double 1
Code
Beep 0 Disable door code
Beep
(Enabled)
To Verify
51
Door Ajar To Select Option
50
Single
2
For callback after strike
Double
2
Mode
Beep
plate release only
Beep
To Verify
51
3
For callback anytime
door is opened
Forced To Select Option
60
Single
010 to 255 (unit disconnects
Double 120 sec.
Disconnect
Beep in 10 to 255 sec.)
Beep
Time-Out
To Verify
61
Reset Options To Select Option
70
Single ## (to restore factory default
Double
N/A
to Factory
Beep
conditions)
Beep
Defaults
To Verify
71
NOTE: The Door Ajar Delay (Option Selection) will begin when the call to the door speaker is disconnected.
4-8 Installation - Dedicated Trunk Port