Filter
Top Products
Table 3-1. AT&T Door Phone Controller Option Selection Information
Mode Option/
Listen
Listen
Options
Verify
Press
Press
For
Default
Delay Before
To Select Option
00
Single 000 to 255 for 0 to 255 Double
30 sec.
Door Ajar
Beep seconds of delay after strike Beep
Call-back
To Verify
01
plate release stops until
AT&T Door Phone Controller
calls back to indicate that
door is ajar
Ring/Chime
To Select Option 10
Single 24 (for 2 sec. on 4 sec. off
Double
2 sec./
Cadence
Beep cadence)
or
Beep 4 sec.
To Verify
11
15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime To Select Option 20
Single 00 to 99 (0 to 99 second(s)
Double
30 sec.
Duration
Beep
ring/chime)
Beep
To Verify
21
Door Unlock
To Select Option 30
Single 4 digits (first digit must be
Double 6736
Code
Beep 0,3,4,5,6,7 or 8
Beep
“OPEN”
To Verify
31
remaining digits can be set
from 0 to 9)
Door Unlock
To Select Option 40
Single 00 to 99 (door lock active
Double 4 sec.
Duration
Beep time in sec.)
Beep
To Verify
41
Enable Door
To Select Option 50
Single
1
Enable door code Double
1
Code
Beep 0 Disable door code
Beep
(Enabled)
To Verify
51
Door Ajar To Select Option 50
Single 2 For callback after strike
Double 2
Mode
Beep
plate release only
Beep
To Verify
51
3 For callback anytime
door is opened
Forced
To Select Option 60
Single 010 to 255 (unit disconnects
Double 120 sec.
Disconnect
Beep
in 10 to 255 sec.)
Beep
Time-Out
To Verify
61
Reset Options
To Select Option 70
Single ## (to restore factory default
Double
N/A
to Factory
Beep
conditions)
Beep
Defaults
To Verify
71
NOTE: The Door Ajar Delay (Option Selection) will begin when the call to the door speaker is disconnected.
.
3-6 Installation —
Home/Residential