Filter
Top Products
Table 6-1. AT&T Door Phone Controller Option Selection Information
Mode Option/ Listen Listen
Options
Verify
Press
For
Press
For
Default
Delay Before
To Select Option
00
Single 000 to 255 for 0 to 255 Double 30 sec.
Door Ajar
Beep
seconds of delay after strike
Beep
Call-back
To Verify 01
plate release stops until
AT&T Door Phone Controller
calls back to indicate door is
ajar
Ring/Chime
To Select Option
10
Single 24 (for 2 sec. on 4 sec. off Double
2 sec./
Cadence
Beep
cadence)
or Beep
4 sec.
To Verify 11 15 (for 1 sec. on 5 sec. off
cadence)
Ring/Chime
To Select Option
20
Single 00 to 99 (0 to 99 second(s) Double 30 sec.
Duration
Beep
ring/chime)
Beep
To Verify 21
Door Unlock
To Select Option
30
Single 4 digits (first digit must be
Double 6736
Code
Beep
0,3,4,5,6,7 or 8;
Beep “OPEN”
To Verify
31
remaining digits can be set
from 0 to 9)
Door Unlock
To Select Option
40
Single 00 to 99 (door lock active
Double
4 sec.
Duration
Beep time in sec.)
Beep
To Verify
41
Enable Door
To Select Option
50
Single
1
Enable door code
Double
1
Code
Beep
0 Disable door code
Beep (Enabled)
To Verify 51
Door Ajar
To Select Option
50
Single
2
For callback after strike
Double
2
Mode
Beep
plate release only
Beep
To Verify 51
3
For callback anytime
door is opened
Forced To Select Option
60
Single 010 to 255 (unit disconnects
Double 120 sec.
Disconnect
Beep
in 10 to 255 sec.)
Beep
Time-Out
To Verify
61
Reset Options
To Select Option
70
Single ## (to restore factory default
Double
N/A
to Factory
Beep
conditions)
Beep
Defaults
To Verify
71
NOTE: The Door Ajar Delay (Option Selection) will begin when the call to the door speaker is disconnected.
6-8 Installation - No Dedicated Trunk/Station Port