Filter
Top Products
131130
Using PT-H99 as a transceiver
You can communicate between PCTs that are both registered in the same Home Base Unit
(HBU). However, the communication should be within 3 minutes.
Before using your PT-H99 as a transceiver, you have to:
1. Register your PT-H99 in the Home Base Unit (HBU). (See page 126.)
2. Select the HBU’s number, because your PT-H99 can be registered in 5 HBUs.
(See page 127.)
3. Set the PT-H99’s mode to “PUB&TRANS” or “TRANSCEIVER”. (See below.)
• PUB & TRANS: to use PT-H99 as an ordinary PCT and transceiver
• TRANSCEIVER: to use PT-H99 as a transceiver
The following example assumes PCT 1 (yours) calls PCT 2 (receiver).
To set the transceiver mode:
1 In standby mode, press ,
, and