Filter
Top Products
9392
To send an S-mail:
1 In standby mode, press
and successively.
2 Press .
3 Enter text.
See page 32 for text input.
Sending an S-mail
You can send a short mail consisting of up to 20 characters. For short mails, you cannot enter
text in Thai.
4 When you complete entering a
mail, press
or .
5 Dial a phone number, and press
.
You can turn the Easy Shuttle to use a
redial number or Phone Book.
Hints:
• You can talk with the other party after an S-mail is sent if you set the Continue mode
to “On”. (See page 103 to set the Continue mode.)
• In step 2, you can also use the 1 button.
If you enable the Succession mode, you can send an S-mail up to 100 characters, where the
mail is divided into 20-character blocks to be sent.
To send an S-mail over 20
characters:
1 In standby mode, press
and successively.
2 Turn the Easy Shuttle to select
“SUCCESSION”.
3 Press , and turn the Easy
Shuttle to select “On”.
4 Press to set the Succession
mode.
The normal display returns after a few
seconds.
5 Enter text.
See steps 1 to 4 of “To send an S-mail”
on page 92.
6 Dial a phone number, and press
to enter a pause (P), then
key in your PCT number code.
7 Press .
PT-H99 beeps each time 20 characters
of mail are sent.
Hints:
• Because a mail is sent in 20-character
blocks, the last block might reach first
at the receiving side.
• Each 20-character block is counted as
one call. So, if you send 30 characters
of mail, you will be charged by 2 calls.
• In step 2, you can also use the 8 button.
You do not need to press F/SELECT in
step 3.
• In step 3, you can also use the numeric
button.
1: On
3: Off
You do not need to press F/SELECT in
step 4.
PCT
number
code
Pause
*PT-H99(AH)_06E 01.10.11, 9:16 PM92-93