321 Studios F-560 Two-Way Radio User Manual


 
1-23GETTING STARTED
1
2
3
4
5
6
7
8
9
10
11
GETTING STARTED
12
13
AI
Using the Energy save mode
When the machine has been idle for a predetermined amount of time, the Energy
Save mode will activate to conserve power. By default, the machine will automati
-
cally enter the Energy Save mode after 5 minutes of idle time.
While the Energy Save mode:
• The machine stops the pre-heating for printing and turn off the display.
(However, the scanner lamp will not shut off.)
• [Energy Save] lights in green to indicates that the machine is in the Energy
Save mode.
• Press [Energy Save] to recover from the Energy Save mode.
NOTE:
• The Energy Save mode will not activate in the following cases, even if you
press [Energy Save].
While scanning documents
When a document is set in the ADF
* Energy Save mode will not activate when “Calibrating Scanner” appears in
the display.
When the print error occurs (ex: out-of-paper status, paper jam)
When the telephone line is used
• When cooling fan is rotating
• For the Energy Save Mode setting, see page 12-12.
• Only the display backlight will be turned out in the following cases.
When the machine is not used for more than 10 minutes. (The backlight
may not be turned out in some cases, such as while scanning documents.)
When printing received documents of fax/internet fax, during PC printing,
or when automatically printing lists (ex: check message) in the Energy Save
mode.
To turn on the backlight, press any key on the display or on the control panel.