Uniden BC780XLT Two-Way Radio User Manual


 
38
Important!
7. Press TRUNK for 2 seconds.
A tone sounds, and
E, M, or L icon appears on the display according to the system
selected.
Note: To clear a mistake while entering the frequency,
press (decimal key) repeatedly until the
display is cleared.
If you enter a frequency which is out of the
systems trunking range, a distinctive beep
sounds and ERROR appears on the display.
Selecting Trunking Programming Menu Mode
To change the system type which your scanner monitors, you must be in the Trunking
Programming menu mode.
To select this mode, follow these steps:
1. Press
MENU.
2. Press
or to select TRUNK DATA and then
press
E.
3. Select the bank you want to program using
, or
VFO and then press E.
Remember! You can also use the VFO control for scrolling. Also instead of pressing
E, you can press the VFO/SELECT control or press the SELECT/MUTE key.
Selecting Trunking System Type
1. Select TRUNK TYPE using , or VFO and then
press
E, SELECT or VFO.
2. Select the system type you want to program
using
, or VFO and then press E, SELECT
or VFO.