Filter
Top Products
SpectraLink Corporation Installation and Operation
Link WTS – Link 150 M3 MCU
9.4 Replace a Handset
If a handset breaks or needs to be replaced, the old handset must be deleted and the
new handset added.
Delete Old Handset
1. Make sure all unregistered handsets are off. If this is not done an unregistered
handset may unintentionally register to an available line.
2. Move the mode switch to the REGISTER position on the MCU.
3. Press the STEP button until the LED for the line to be deleted is flashing red.
4. Press the DEL/ENTER button.
You can now register a new handset or return the mode switch to the NORMAL
position.
Register New Handset
1. Make sure all unregistered handsets are off.
2. Move the mode switch to the REGISTER position.
3. Press the STEP button until the desired line to be registered is flashing red. Only
unregistered lines can be registered.
4. Press PWR on the handset that needs to be registered. The LED should change
to mostly on once the handset is registered.
5. Wait at least three seconds and then press END.
6. Return the mode switch to the NORMAL position.
7. To assign the extension number, hold down the FCN key until Volume Level
displays. Press the # > key until EXTENSION displays on the handset. Press 0, then
enter the correct extension number.
8. When the handset is turned on, the extension will be displayed. Test the handset
by placing a call to each handset to verify that the correct handset rings.
PN: 72-0075-01-F.doc Page 39