Filter
Top Products
Installation
10
On a Desk Top
1. Insert the two tabs at the top of the
narrow end of the supplied bracket into
the base’s upper tab slots, then press
down on the bracket’s latches and
insert them into the lower slots.
2. Connect the handset cord to left side of
the phone and corded handset.
3. Plug one end of the supplied long
modular cord into the
TEL LINE jack on
the back of the base.
4. Plug the modular cord’s other end into
a modular phone line jack.
5. Insert the supplied AC adapter’s barrel
plug into the
DC IN 9V jack on the back
of the base.
6. Route the adapter’s cord through the
strain relief slot on the base, then plug
the adapter into a standard AC outlet.
7. Lift the base’s antenna to a vertical
position.
CAUTION
You must use
a Class 2
power source
that supplies 9V DC and
delivers at least 350 mA.
Its center tip must be set
to positive and its plug
must fit the phone’s DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
!
43-3880.book Page 10 Monday, June 28, 2004 2:07 PM