Filter
Top Products
SpectraLink Wireless Telephone Configuration
PN: 1725-36038-001_B.doc 35
Use g only if all of your infrastructure devices use only 802.11g. The
handsets will operate up to 54 mb/s in this mode.
Use b & b/g mixed if some of your infrastructure components only
understand 802.11b. The handsets will operate up to 11 mb/s.
Subbands have not been established for the b and b/g mixed or the
g only mode at this writing. Provision is made in the software to
accommodate these ranges once established. Newly added
subbands may not appear in the above table.
Subband
Once a mode is set the subband list will display, if applicable.
Only those ranges which are allowed in the set regulatory domain
and that pertain to the set mode are displayed. Note that for
802.11a the bands labeled
DFS will vary depending on the set
regulatory domain. Multiple subbands may be set. Navigate to the
desired subband and set with
NavOK. The Transmit Power menu
will open. Once the
Transmit Power setting is done, you will be
returned to the subband list.
To deselect a subband, navigate to it and press
NavOK.
Once the subband settings are as desired, press the
Done softkey to
exit to the
Network Setup menu.
Transmit power
For subbands: The Transmit Power list opens when NavOK is
pressed from the
Subband menu. A transmit power setting is
required for each subband. Only one level may be set per
subband. Only those power levels which apply to the
regulatory domain and 802.11 mode are listed. Navigate to the
desired level and press
NavOK to set and return to the subband
list. Another subband may be selected which repeats the
process.
If the highlighted power transmit level is legal on all of the
subbands for the set mode, an
All softkey will appear. Press the
All softkey to apply that level to all subbands and return to the
subband menu where all subbands will now be selected.
All
overrides any previously set power transmit levels.
Without subbands: When the 802.11 mode has no subbands, the
Transmit Power list opens when NavOK is pressed to set the
mode. Only those power levels which apply to the domain