Filter
Top Products
SpectraLink Wireless Telephone Configuration
PN: 1725-36038-001_B.doc 33
Authentication
Select either Open System or Shared Key.
WEP Enable/Disable
Select either Enable WEP or Disable WEP.
Key Information
Default
Key Enter the key number specified for use by the
handsets. This will be
1 through 4.
Key Length Select either 40-bit or 128-bit depending on the key
length specified for use at this location.
Key 1-4 Scroll to the key option that corresponds to the Default
Key that was entered above. Enter the encryption key as a
sequence of hexadecimal characters. (Use the
2 and 3 keys to
access hexadecimal digits A through F.
Rotation Secret
This is used for proprietary WEP key rotation. Refer to your
custom document if this feature is supported in your system.
WPA2-PSK The security features of WPA2 (Wi-Fi Protected Access)
using PSK are available and may be used if supported by the APs in
the facility. Select either
Passphrase and enter a passphrase between
eight and 63 characters in length or
Pre-Shared Key and enter the 256-
bit key code.
WPA-PSK The security features of WPA (Wi-Fi Protected Access)
using PSK (pre-shared key) are available and may be used if
supported by the APs in the facility. Select either
Passphrase and enter
a passphrase between eight and 63 characters in length or
Pre-Shared
Key
and enter the 256-bit key code.
Cisco FSR (Fast Secure Roaming) In order to provide the highest level
of security without compromising voice quality on Cisco Aironet
wireless LAN APs, Polycom and Cisco Systems have cooperated to
implement the Fast Secure Roaming mechanism. FSR is designed to
minimize call interruptions for SpectraLink 8020/8030 Wireless
Telephone users as they roam throughout a facility. Existing Aironet
350, 1100, and 1200 APs may require a firmware upgrade to support
FSR. Cisco FSR requires advanced configuration of the Cisco APs in
your site. See your Cisco representative for detailed documentation
on configuring the APs and other required security services on the
wired network. To configure Cisco FSR on a handset, you must enter
a Radius Server username and password into each handset.