Filter
Top Products
SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
18 PN: 1725-36038-001_B.doc
Startup Sequence
The SpectraLink 8020/8030 Wireless Telephone goes through an
initialization sequence at startup. The line icons 1-9 display and count
down as the handset steps through this sequence. This is usually very
rapid. If there is difficulty at any step that prevents initialization from
continuing, an error message will display and the related icon(s) will
stay on. Please see the error table at the back of this document for
instructions on how to handle error messages that occur during
initialization.
Icon The icon(s) shown in bold turns off when:
123456789
The handset has located and authenticated and associated with at least one AP, and is
proceeding to bring up higher-layer networking functions.
12345678
The handset is either configured for Static IP, or if configured for DHCP, the DHCP
discovery process has started.
1234567
If DHCP is configured, a DHCP response was received which contains a good DNS
server configuration.
123456
Note: Only valid on non-SRP protocol. Indicates one of the following:
Static IP configuration, or
SpectraLink 8000 SVP Server address found in DHCP response, or
SpectraLink 8000 SVP Server address found via DNS lookup.
12345
All networking functions are complete (notably, DHCP), and the handset is proceeding
with establishing the SRP link to the SpectraLink 8000 SVP Server.
1234
The SRP link is established; all network stack initialization is complete, proceeding with
application-specific initialization.
123 SIP application startup. Icon 3 is extinguished if a generic SIP config file is found.
12 Icon 2 is extinguished if a handset specific SIP config file is found.
(no icons)
Registering
Handset is attempting to register each of the specified line contacts.
(no icons)
EXT.
XXXXX
Handset has registered with at least one contact on one proxy server. Initialization is
complete. The handset is in standby mode ready to receive and place calls. The line one
contact is displayed.