Filter
Top Products
SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
30 PN: 1725-36038-001_B.doc
To optimize battery life, the interval between sending out ELP
updates will vary based on handset state. It is expected that ELP
updates will occur at most every two to six seconds and at least
every few minutes. If improved tracking capability is desired, set the
transmit interval for a shorter time between ELP updates. Increasing
the frequency of transmissions will decrease battery life.
Location Server IP Allows the user to statically enter the IP address of
the EPE. Enter the IP address and press
NavOK to save.
Ekahau clients are not expected to find the EPE automatically.
Regardless of the handset’s selection of DHCP or static IP, the EPE
IP address must be statically entered in the Ekahau admin menus or
HAT.
ELP Port Allows the user to select the port number which ELP updates
get sent to at the Location Server IP address. It must match the value
configured in the Ekahau Positioning Engine for proper functionality.
The ELP port number must be greater than zero and less than 65536.
Default is 8552. Enter the port number and press
NavOK to save.
Network Config
IP Addresses
There are two modes in which the handset can operate: DHCP-
enabled or Static IP. Select the mode for operation from the IP
Address menu:
* Use DHCP Will use Dynamic Host Configuration Protocol to assign
an IP Address each time the handset is turned on. If DHCP is enabled,
the handset also receives all other IP Address configurations from the
DHCP server.
Static IP Allows you to manually set a fixed IP Address. If selected, the
handset will prompt for the IP addresses for each configurable
network component. When entering addresses, enter the digits only,
including leading zeroes. No periods are required.
Regardless of the mode in which the handset is operating, the
following components are required and must be configured as part of
the SIP system:
Phone IP The IP address of the handset. This is automatically
assigned if DHCP is used. If using Static IP configuration, you