Filter
Top Products
55
Chapter 3
Advanced Operations
You can program a 4-digit handset/base unit PIN (Personal Identification Number). The factory preset
is 0000. Changing the PIN may prevent the unauthorized use of your unit by another person.
Make sure that the power is ON (p. 11) and the unit is in the standby mode.
Setting the PIN
On the handset
1 Press .
2
Press or until the arrow points
to “Setting Handset”, then press .
3 Press or until the arrow points
to “Other Option”, then press .
4 Press or until the arrow points to
“Change Hset PIN”, then press .
5 Enter the current 4-digit handset PIN.
•The factory preset is 0000.
6 Enter the new 4-digit PIN TWICE.
•If you misdial, press . Digits are erased
from the right. To erase all digits, press and
hold .
C
C
Once you have programmed the PIN, you cannot confirm it. We recommend you write down the
PIN. If you do forget it, please consult your nearest Panasonic Service Center.
Enter Old PIN
1234567890 :
----
5 Enter the new 4-digit PIN TWICE.
•A beep sounds.
•To return to the standby mode, press
.
•If 5 beeps sound in step 4, the entered PIN is
incorrect. Enter the correct PIN.
On the base unit
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press .
4 Enter the current 4-digit base unit PIN.
•The factory preset is 0000.
5
Input Command
5
____
Input Command
5
____ ____
•A beep sounds.
•To return to the standby mode, press
.
•If 5 beeps sound in step 5, the entered PIN is
incorrect. Enter the correct PIN.
1st
2nd
Enter New PIN
1234567890 :
----
Verify New PIN
1234567890 :
----
TCD715NLM(E)-7Advance2* 01.9.17 8:19 PM Page 55